![]() ![]() Step 4: On SW-A, ensure the management PC is part of VLAN 20. Step 3: Connect and configure the management PC.Ĭonnect the management PC to SW-A port F0/1 and ensure that it is assigned an available IP address Security purposes, the administrator wants to ensure that all managed devices are on a separate VLAN. The network administrator wants to access all switch and routing devices using a management PC. Part 3: Enable VLAN 20 as a Management VLAN SW-2(config-if)# switchport trunk native vlan 15 SW-1(config-if)# switchport trunk native vlan 15 On both SW-1 and SW-2, set the port to trunk,Īssign native VLAN 15 to the trunk port, and disable auto-negotiation. The new link must be configuredįor trunking, including all trunk security mechanisms. Trunking has already been configured on all pre-existing trunk interfaces. Step 2: Enable trunking, including all trunk security mechanisms on the link between SW. Using a crossover cable, connect port F0/23 on SW-1 to port F0/23 on SW. Part 2: Create a Redundant Link Between SW-1 and SW- 2 Note : If using the simple PDU GUI packet, be sure to ping twice to allow for ARP. Step 2: Verify connectivity between C2 (VLAN 10) and D1 (VLAN 5). Step 1: Verify connectivity between C2 (VLAN 10) and C3 (VLAN 10).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |